AT&T SPIRIT Attendant Appendix A , Wiring

Appendix A —Wiring

Note the following cabling requirements before 104386545). In addition, you will need a

connecting the equipment. If these limits (which Building Entrance Protector, which can

are the same ones that apply to our current house up to six 4C1S Block Protectors.

SPIRIT System) are exceeded, the SPIRIT Order Model 110ANA1-06 (comcode

Attendant ConnecT/R may not work properly. 105736482). Contact your AT&T representa-

tive for additional information.

● The total wire length from the controller to

the SPIRIT Attendant cannot exceed a total

of 1000 feet of 24- gauge DIW (twisted-pair

copper) wire or 22-gauge D station wire,

plus 25 feet of 4-wire line cord.

● If the SPIRIT Attendant ConnecT/R is

installed outside the building where the

controller is located, using exposed wiring

In-Range/Out-of-Building protectors (IROB

TII Model 371 or ITW Model SP69073, AT&T

order number 31304) must be installed by a

qualified technician. Contact your AT&T

representative for additional information.

● If the SPIRIT Attendant will be in a building

other than where the SPIRIT Attendant

ConnecT/R is located, a Block Protector

must be installed by a qualified technician.

Order an AT&T Model 4ClS (comcode