4Step 1 — Mount the SPIRIT Attendant
ConnecT/R (optional).
The SPIRIT Attendant ConnecT/R is designed
to be placed on your desk or mounted on any
vertical surface.
Do not place it on the floor.
Hardware has been included to mount the
SPIRIT Attendant ConnecT/R on the wall: two
plastic wall-mount tabs, two anchors, and two
#6 screws.
of the tab against the inside of one of the
feet. Repeat for the second tab.
1.
2.
3.
4.
Select an appropriate location. The SPIRIT
Attendant ConnecT/R can be no more than
six feet from its power supply (an AC outlet
that isn’t controlled by a wall switch) and no
more than six feet from the devices attached
to it. The bottom of the SPIRIT Attendant
ConnecT/R should be at least two feet from
the floor.
Position the SPIRIT Attendant ConnecT/R
so the side with the jacks and settings is
down or to the side, but not up.
Remove the backing from the plastic tabs.
Gently position a tab by aligning the end of
the adhesive with the outside edge of the
SPIRIT Attendant ConnecT/R and the side
5.
6.
7.
Press the tabs firmly into position.
With the tabs at the top, hold the SPIRIT
Attendant ConnecT/R against the wall
where you plan to mount it and use a pencil
to mark the location of the holes in the tabs.
The bottom of the SPIRIT Attendant
ConnecT/R should be at least two feet from
the floor.
If you have plywood walls or walls with a
sturdy supporting structure (either wood