Getting started

Battery charging

Once you have installed the battery, the screen indicates the battery status (see table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 16 hours

of continuous charging. See the table on page 33 for battery operating times.

If the screen shows Low battery, you need to charged the battery without interruption for at least 30 minutes to give the handset enough charge to use the telephone for a short time. The following table summarizes the battery charge indicators and actions to take.

Battery indicators

Battery status

Action

 

 

 

 

 

The screen is blank or

The battery has no

Charge without

shows Place in charger.

charge or very little

interruption until the

 

 

 

charge. The handset

screen shows

 

 

 

cannot be used.

Low battery or Handset

 

 

 

 

X (at least 30 minutes).

 

 

 

 

 

The screen shows

Battery has enough

Charge without

Low battery and

 

 

charge to be used for a

interruption until the

 

flashes.

short time.

screen shows HANDSET

 

 

 

 

X (at least 30 minutes).

 

 

 

 

 

The screen shows

Battery is charged.

To keep the battery

HANDSET X.

 

charged, place it in

 

 

 

 

the telephone base or

 

 

 

 

charger when not in use.

 

 

 

 

 

NOTE: If you are on a phone call in low battery mode, you hear four short beeps every minute.

Page 14
Image 14
AT&T TL91370, TL92370, TL92320, TL92270, TL90070, TL91270, TL92220, TL92470, TL92420 Battery charging, Low battery or Handset