2. Hardware Setup

Single Station Installation

The most basic installation is a Single Stage installation, in which no additional Master Views are cascaded down from the first unit. To set up a single stage installation, refer to the installation diagram on the following page as you perform these steps:

1.Plug the monitor, keyboard, and mouse cables for Consoles 1 and 2 into the port connectors located on the rear panel of the CS-228 unit. Each port is labeled with an icon to indicate itself.

2.Plug the microphone and speaker cables (if you are using them), for Consoles 1 and 2 into the port connectors located on the rear panel of the CS-228 unit. Each port is labeled with an icon to indicate itself.

3.Use PS/2 KVM cables (as described in the Cables section on page 4), to connect the monitor, keyboard and mouse ports of the computers to any available CS-228 KVM Port.

4.Plug the power adapter into an AC source; plug the power adapter cable into the CS-228's Power Jack.

5.Turn on the power to the CS-228.

When you turn the unit On, it undergoes a Power On Self Test. If there is a problem, the On Line Port LEDs flash repeatedly according to a pattern that indicates what the problem is:

 

Pattern

Indication

 

 

 

On Line LEDs 1 - 8

Flash Simultaneously

Internal RAM Memory Error

 

 

 

On Line LEDs 1 - 8

Flash One After the Other

External RAM Memory Error

 

 

On Line LED pairs 1+2, 3+4, 5+6, and 7+8 Flash

ROM Test Error

One After the Other

 

 

 

 

 

If any of these problems occur, turn the Switch Off, then turn it on again.

(Continues on next page.)

9