|
| Chapter 1. Introduction | |
|
|
| |
|
|
| |
|
|
| |
No. | Compo- | Description | |
nent | |||
|
| ||
|
|
| |
1 | Port | Press a switch to give the KVM focus to the computer attached | |
| Selection | to its corresponding port. | |
| Switches | Simultaneously pressing Buttons 1 and 2 for 3 seconds | |
|
| performs a Keyboard and Mouse Reset. | |
|
| Simultaneously pressing Buttons 7 and 8 starts Auto Scan Mode. | |
|
|
| |
2 | Port LEDs | The Port LEDs are built into the Port Selection Switches. The left | |
|
| ones are the On Line LEDs; the right ones are the Selected Port | |
|
| LEDs: | |
|
| An On Line LED lights GREEN to indicate that the computer | |
|
| attached to its corresponding port is up and running. A flashing | |
|
| LED indicates that the Port is being used for cascading to | |
|
| another switch. | |
|
| A Selected LED lights ORANGE to indicate that the computer | |
|
| attached to its corresponding port is the one that has the KVM | |
|
| focus. The LED is steady under normal conditions, but flashes | |
|
| when its port is accessed under Auto Scan Mode. | |
|
|
| |
3 | Reset | Pressing this switch in performs a system reset. | |
| Switch | Note: The switch is recessed and must be pushed with a thin | |
|
| ||
|
| object - such as the end of a paper clip, or a ballpoint pen. | |
|
|
| |
4 | Firmware | During normal operation and while performing a firmware | |
| Upgrade | upgrade, this switch should be in the NORMAL position. If a | |
| Recovery | firmware upgrade operation does not complete successfully, this | |
| Switch | switch is used to perform a firmware upgrade recovery. | |
|
| See Firmware Upgrade Recovery, page 50 for details. | |
|
|
| |
5 | Firmware | The Firmware Upgrade Cable that transfers the firmware upgrade | |
| Upgrade | data from the administrator's computer to the KH1508 / | |
| Port | KH1516 (see page 45), plugs into this | |
|
|
| |
6 | Power LED | Lights to indicate that the KH1508 / KH1516 is powered up and | |
|
| ready to operate. | |
|
|
| |
7 | Station ID | The KH1508 / KH1516's Station ID is displayed here. If this is a | |
| LED | Single Station installation (see page 12), or the First Station on a | |
|
| Daisy Chained installation (see page 15), the KH1508 / | |
|
| KH1516 has a Station ID of 01. | |
|
| On a Daisy Chained installation, the KH1508 / KH1516 auto- | |
|
| senses its position and displays the Station ID that corresponds to its | |
|
| place in the chain. (see Port ID Numbering, page 19, for details). | |
|
|
|
7