Chapter 1. Introduction
Keyboard Module
1
9
2 | 8 |
|
3
|
| 4 |
| 7 |
|
| 5 | 6 | |
|
|
| ||
|
|
|
| |
|
|
| ||
No. | Component | Description | ||
|
|
| ||
1 | Port LEDs | An On Line LED lights to indicate that the device attached | ||
|
| to its corresponding port is up and running. | ||
|
| A Selected LED lights to indicate that the computer | ||
|
| attached to its corresponding port has the KVM focus. | ||
|
|
|
|
|
2 | Keyboard | Standard |
|
|
|
|
|
|
|
2 | Touchpad | Standard mouse touchpad |
|
|
|
|
| ||
4 | Reset Switch | Pressing and holding this switch in while powering on the | ||
|
| unit causes the KL9108 / KL9116 to revert to the original | ||
|
| factory installed firmware version – allowing you to recover | ||
|
| from a failed firmware upgrade. |
| |
|
| Pressing and holding this switch in for more than three | ||
|
| seconds performs a system reset. | ||
|
| Note: The switch is recessed and must be pushed with a thin | ||
|
| object - such as the end of a paper clip or a ballpoint pen. | ||
|
|
| ||
5 | Port Selection | The left button (DOWN), shifts the KVM focus down | ||
| Switches | through the ports (Port 7 → Port 6, etc.). After Port 1, it | ||
cycles back to the last port.
The right button (UP), shifts the KVM focus up through the ports. After the last port, it cycles to Port 1.
(Continues on next page.)
9