(F4 ADM: continued)
Setting | Function |
SET QUICK | This function lets the Administrator select which Ports to include as |
VIEW PORTS | Quick View ports. |
| w To select/deselect a port as a Quick View Port, Double Click the |
| port you want, or use the Navigation Keys to move the highlight |
| bar to it, then press [Enter]. |
| w When a port has been selected as a Quick View Port, an |
| arrowhead displays in the QV column of the LIST on the Main |
| Screen to indicate so. When a port is deselected, the |
| arrowhead disappears. |
| w If one of the Quick View options is chosen for the LIST view |
| (see F2 LIST, p. 39), only a Port that has been selected here |
| will display on the List. |
| w If one of the Quick View options is chosen for Auto Scanning |
| (see SCAN/SKIP MODE, p. 41), only a Port that has been |
| selected here will be Auto Scanned. |
| The default is for no ports to be selected. |
|
|
SET | This function allows the Administrator to define Operator access to |
ACCESSIBLE | the computers on the installation on a |
PORTS |
|
| For each Operator, select the target Port; then press the [Spacebar] |
| to cycle through the choices: F (Full access), V (View Only), or |
| blank (No access). Repeat until all access rights have been set, |
| then press [Enter]. The default is F for all users on all Ports. |
| Note: A blank setting means that no access rights are granted. The |
| Port will not show up on the User’s LIST on the Main Screen. |
|
|
SET ACCESS | If there is no input from the console accessing a particular port for |
TIMEOUT | the amount of time set with this function, the port is released, |
| allowing it to be accessed by the other consoles. |
| To set the timeout value, key in a number from 0 - 255 seconds, |
| then press [Enter]. |
| If the number is 0 [zero], this function is disabled. The default is 5 |
| seconds. |
|
|
(Table continues on next page)
44 