Chapter 2. Hardware Setup

PC Installation

Refer to the Installation Diagram on p. 10 (the numbers in the diagram correspond to the numbers of the steps), as you do the following:

1.For each server or serial device, plug an RJ45 to Serial adapter into its serial port. (See RJ-45 to Serial Adapters, page 78, for details on choosing the appropriate adapter.)

Note: RJ-45 to Serial adapters require a separate purchase. To purchase RJ-45 to Serial adapters, contact your dealer.

2.Use standard Ethernet cable to connect any available port on the SN0108 / SN0116's rear panel to the adapter.

3.If you choose to install a serial modem for OOB operation (see Chapter 6), use standard Ethernet cable to connect any available port on the SN0108 / SN0116's rear panel to a DTE to DCE serial adapter (see RJ-45 to Serial Adapters, page 78 for details on choosing the appropriate adapter), then plug the adapter into the modem's serial port.

Note: This step is optional.

4.Plug the cable that connects the SN0108 / SN0116 to the network or the Internet into its LAN port.

5.Use the AC power cord provided with this package to connect the SN0108 / SN0116's Power Socket to an AC power source.

After you connect all the cables, you can turn on the SN0108 / SN0116.

9