SN0108 / SN0116 User Manual

Indirect HyperTerminal Connection

This method uses HyperTerminal to phone into the SN0108 / SN0116 from a remote location.

Setup:

1. Set up your hardware configuration to match the diagram, below

:

 

 

SN0108 / SN0116

 

 

 

 

Ethernet Cable

Serial Modem Cable

 

 

 

Phone Line

DTE to DCE

 

 

 

Adapter

Remote

Operator

Modem

Modem

ŠOn the remote computer side, use a standard 9 pin serial modem cable (pin 2 to pin 2; pin 3 to pin 3) to connect the computer to the modem.

ŠOn the SN0108 / SN0116 side, use Cat 5 cable and an RJ-45 to Serial adapter to connect a modem to any of its serial ports (see the PC Installation Diagram:, page 10). Also see RJ-45 to Serial Adapters, page 78, for details on choosing the appropriate adapter. The usual choice for connecting to a modem is SA0142.

Note: Be sure that the port you specify as the Console Port in the OOBC dialog box (see p. 22) matches the port that you connect the modem to. Change the setting, if necessary.

2.Create a HyperTerminal connection.

a)Start with Step 2 of the Direct HyperTerminal Setup section (p. 47).

b)For Connect using: in Step 4, select the type of modem connected to your computer from the list. If your modem doesn't appear in the list, select Standard 28800bps Modem.

c)Follow Steps 5-9 to complete the setup and create the connection icon.

52