DHSIP Source Input Wall Plate
Installation
The DHSIP is designed to mount in a standard single- gang rough-in box (J Box). Mount the unit in close proximity to the location of the source that will be connected to it.
Note: Do not mount the DHSIP in the same rough-in box as high voltage devices such as electrical outlets or switches.
After running Cat-5 and terminating the ends, route the wire into the back of the rough-in box, connect it to the RJ-45 connector on the rear of the DHSIP, and mount using the 2 provided screws. See Figure 2.2.
Rough-In Stud
Screw
Screw
Cat-5
Figure 2.2: Installing the DHSIP
8 | ©2008 • All rights reserved. |
