Audio-Technica AT-LP2D-USB manual Installing Cakewalk pyro Audio Creator software, for PC use only

Installing Cakewalk pyro Audio Creator software	EN
(for PC use only)

1.Before installing software, assemble the turntable, following directions in the included AT-LP2D-USB Turntable Owners Manual.

2.Plug the AC cord on your turntable into an AC power outlet.

3.Next, use the included USB cable to connect the turntable to your PC's USB port.

Using the supplied 3.5 mm-to-RCA female adapter cable, you can plug a pair of headphones directly into the line output of your turntable. This will allow an additional means of monitoring while recording, although you will not be able to adjust the level (volume) of your headphones, because the turntable has a constant output level.

USB

RCA

AC

USB cable (included)

Included adapter cable (RCA

Cables	to 3.5 mm stereo female
Red to Red
White to Black

4.Make certain your self-powered speakers are plugged into the line-out RCA plugs of the AT-LP2D-USB turntable, and that the Phono/Line switch on your turntable is switched to Line.

Typical connection for:

Speakers with

RCA inputs

Speakers with 3.5 mm

stereo input (using

adapter cable)

Cables

Red to Red

Included adapter cable (RCA

White to White

to 3.5 mm stereo male)

Either connection to the turntable (speakers or headphones) will allow you to monitor the album that you're recording. NOTE: the system will operate without speakers or headphones. Both pyro Audio Creator and Audacity offer a software play-through/monitor feature that allows you to listen to the album through your computer while recording.

5.Turn your computer on. The computer may display a detection message for indicating that a new device is connected.

6.Insert the included Cakewalk pyro Audio Creator CD. An AutoPlay window for the Audio Creator New Hardware Wizard will appear. Click Install or Run program, depending upon your preference. Follow the directions on the pop-up windows to install or run the software.

7.Re-start your computer.

3