![](/images/new-backgrounds/1326545/32654525x1.webp)
Using the 1550 Field Setup Tool
System Calibration and Setup
The Model 1550 is a liquid crystal display that shows the setup menus and settings for Series 1500 Intercom Systems. The entire system can be calibrated from one Counter Station. Connect the 1550 Field Setup Display to the RJ45 jack on the underside of any live Counter Station. (The jack is at an angle.) Upon connection, the 1550 will display “SERIES 1500 EQUIPMENT CALIBRATION PLATFORM”.
•Hold the SETUP key on the Counter Station for one second to enter Setup Mode. The 1550 displays the top level of the menu shown on page 4.
• | To navigate the menus, use the |
| VOLUME UP and VOLUME DOWN |
| keys to move the cursor. |
• | Use SETUP to enter a submenu or |
| confirm a selection, and PRIVACY |
Using the Keypad for Navigation
| to go back. |
• | Any changes you make are |
| recorded as you exit each menu. |
| When you exit Setup Mode, you |
| must choose to either save all |
| changes and exit or exit without |
| saving. |
• | If you need to |
| simply press SETUP for 1 second. |
CAMERA = Select next or previous Station (after selecting a single Lane or Counter Station)
SETUP = Enter or Confirm
1 2 3 4
5 6 7 8
9 10 11 12
13 14 15 16
VOLUME = Move menu cursor up and down
PRIVACY = Go Back to previous menu
Power User Tips
Setup Menu Map
•For faster menu navigation, submenus may be selected by touching the key that is lit RED corresponding to the menu item (see the numbered keys above). For instance, to enter BLOWER MOTOR DELAY, press 1 and then 1.
•To Exit Setup Mode from any menu, hold SETUP for one second and follow the prompts on the 1550.
•After adjusting a Lane Station or Counter Station, use the CAMERA UP or CAMERA DOWN keys to select other stations for adjustment without leaving the submenu.
1:SYSTEM PARAMETERS
2:LANE PARAMETERS
3:TELLER PARAMETERS *
4:SET DEFAULTS
5:MEMORY CARD *
6:EXIT
1:BLOWER MOTOR DELAY 2:POWER SAVE DELAY **
3:SUPERVISOR TELLER * 4:LN MIRROR DISABLE **
5:TRAFFIC SENSOR TONE 6:BACKGRND THRESHOLD
1:SINGLE LANE
3:GROUP OF LANES 4:ALL LANES 5:CANCEL
1:THIS TELLER 2:SINGLE TELLER 3:GROUP OF TELLERS 4:ALL TELLERS
5:CANCEL
1:CANCEL
2:FACTORY DEFAULTS
1:CANCEL
2:WRITE TO MEM. CARD 3:READ FROM MEM. CARD 4:FIRMWARE UPGRADE
1:CANCEL
2:EXIT AND SAVE 3:EXIT WITHOUT SAVING
1:INBOUND VOLUME LVL 2:OUTBOUND VOLUME LVL 3:OPEN LOOP GAIN 4:HANDSET MIC LVL 5:HANDSET SPKR LVL 6:RINGTONE OVERRIDE *
7:HALF DUPLEX ONLY 8:PROGRAM AUDIO ABATE *
9:RELAY OPERATION
1:KEY ASSIGNMENT **
*Not available for 1 on 1 configurations
**Not available for 1509 Audio Hub
Audio Authority® Series 1500 Installer’s Reference Guide 13