Audiovox 1525 owner manual Up Button

located above the LCD Panel (8) will light while the PTT Button is pressed. Releasing the button allows the unit to revert to standby mode. When receiving an incoming signal, a green monitor LED indicator will light and the received signal strength indicator will display the relative strenth of the signal.

The PTT Button can also be used as a two-way call ringer. Pressing the button twice quickly will call another party on the same channel. You will hear a confirming melody.

Up Button (10):

In the standby mode, pressing this button briefly will change the frequency to the next higher channel. Holding button down will cycle through channels rapidly. (Channels 1-15)

Down Button (11):

In the standby mode, pressing this button briefly will change the frequency to the next lower channel. Holding button down will cycle through channels rapidly. (Channels 1-15)

Mode Button (12):

In the standby mode, pressing this button momentarily will enter the function edit mode. Subsequent presses will cycle to each mode.

First Press: Coded Tone Controlled Squelch System (CTCSS) Second Press: Voice Activated Transmission (VOX) Level

Third Press: Channel Scan/Skip List Fourth Press: Beep ON-OFF

Fifth Press: Busy Channel Lock Out (BCLO) ON-OFF Sixth Press: Squelch Level

Seventh Press: Priority Channel

Emergency Call Button Button (14):

Pressing this button will set the transceiver to the Emergency Channel (Channel 10, 462.6750 MHz). Usually, this channel is not monitored, but is to be used in emergency situations pertaining to the immediate safety of life or property.

9