Audiovox ACD-12 128-6196A 11 of, Cd Player Error Codes, Setting The Clock, TI0NS, cq RESET BUTTON

the auxiliary input mode, the portable audio device will now operate through the audio system of the radio using the volume, tone and balance controls of the radio for

adjustment of the sound.

cp TIME/FREQUENCY SELECTOR (T/F)

This unit can display either the clock time or radio frequency/CD player functions. Ordinarily, the radio frequency or CD player track in- dication is displayed, but the display can also show the time when this button is pressed. The time will then be displayed for approximately 5 seconds after which it will return to the radio or CD player function display.

The correct time-of-day can also be set into the unit by pressing the Time/Frequency

Selector button. This procedure is outlined later in these operating instructions.

cq RESET BUTTON

A Reset button is located on the front panel of the unit to the right of the LED display. The Reset function is provided to protect the microproces- sor circuitry and should only be activated under the following circumstances as it will erase the time and pre-set memories:

1.Upon initial installation after all wiring is completed.

2.If there is a malfunction of any of the switches on the unit, pressing the Reset button may clear the system and return to normal opera- tion.

ERROR CODE / OPERATING INSTRUC

CD PLAYER ERROR CODES

If a problem should develop while operating the CD player, an error code (ER-1, ER-2, ER-3, etc.) may appear on the display panel. This can indicate a number of problems with the unit, includ- ing a mechanical error or an error in the microprocessor control of the player. If an error code should appear, try ejecting and re-loading the disc into the player. While the disc is out of the unit, make sure it is clean, undamaged, and loaded correctly (label surface up). You may also try activating the RESET button ?G on the unit, but this will also erase the time memory.

If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.

SETTING THE CLOCK

1.Turn the vehicle ignition and radio on.

2.Press and hold the Time/Frequency button cp for approximately 2 seconds; the time display will begin to flash.

3.Within 5 seconds of selecting the flashing display, press the VOL + button to adjust the hours and the AM/PM indication to the desired setting.

4.Press the VOL - button to adjust the minutes to the desired time.

4.Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and normal operation will resume.

TI0NS

11

128-6196A

11 of 16