Audiovox DPF710K manual Wall Surface

Installation (Cont)

Flat-Head Self-Tapping	Wall Surface	Drill 1/4" Hole
		(2 Places)
Screw (2)

Mounting Hole

Template

Wall Bracket	Wall Mount	Plastic Wall
Mounting Tabs	Bracket	Anchor (2) if
		Needed

homebase Wall Mount Installation Using the Wall Mount Bracket

Note: If the wall bracket is to be mounted using the foam adhesive pads, the procedure will be the same as that for the refrigerator mount as described on page 7.

If the wall bracket is to be mounted using screws, proceed as follows:

1.Position the mounting hole template at the desired place on the wall; level the template and mark the position of the two upper holes.

2.Drill two holes using a 1/4" (6mm) drill bit. If a wall stud is not present, insert the plastic anchors into the holes until flush with the wall surface .

Caution: Do not over tighten the screws; otherwise, the wall bracket could be damaged

3.Align the wall bracket with the two holes and/or wall anchors; insert two flat-head screws and secure the wall bracket to the wall.

4.Connect the power adapter plug to the DC input connector at the rear of the homebase.

5.Choose the direction of the adapter wire in reference to the AC wall outlet. Place the DC wire in the correspond- ing wire notch.

6.Check the amount of wire required to reach the AC outlet. Spool excess wire on the four posts inside the rear cavity of the homebase.

7.Attach the homebase to the bracket by lining up the homebase bracket mounting holes with the wall bracket mounting tabs, and slide the homebase down until the mounting tabs engage the mounting hole slots.

8.Cover the power adapter wire with the clear, black or white wire cover; seal the cover using the double-sided tape and dress the wire, adhering it to the wall surface.

DPF710K 9