Graco 16N656, 16H960, 16N655, 16N927, 16N654 Route wires from motor down the handle

3.Set motor housing into right half of clamshell and loosely install two bolts (42) to motor housing as shown below.

42

ti19629a

4. Route wires from motor down the handle.

ti19630a

5.Install trigger over top of wires. Route trigger wires behind trigger.

ti19631a

6. Insert trigger lock over trigger with o-ring facing out.

ti19632a

Repair

7.Press ground stud into left half of clamshell. Tighten nut onto stud. Install ground terminal to stud and tighten second nut onto stud. Install wire up along handle.

ti19633a

8.Insert static wick into right half of clamshell and install left clamshell to right clamshell.

ti19634a

NOTICE

Wires can become damaged when pinched between clamshell halves. Make sure no wires are pinched during reassembly.

9.Install bolts (42) to motor housing and install screws (43) to connect clamshell halves. Make sure LED lights and static wick are securely in place. Tighten bolts (42) to 50 in-lb (5.6 N•m) and screws (43)

to 9 in-lb (1 N•m).

43

42

ti19635a

10.Install pump module to drive module. See Pump Module/Drive Module, page 31.

34 3A2308C