Pump Rebuild Kit
Removal
1.Remove pump module from drive module. See Pump Module/Drive Module, page 31.
2.Remove outlet valve from pump module and set aside. See Outlet Valve, page 29.
3.Remove inlet valve from pump module and set aside. See Inlet Valve, page 7.
4.Remove accumulator (16), front valve (18), and prime valve (17) from pump module and set aside.
16
17
18
ti19645a
5. Remove four bolts (21) from pump module.
21 
ti19646a
6. Separate pump portions as shown below.
ti19647a
7.Inspect wobble drive assembly. If bearing race is visible as shown below, replace wobble drive assembly.
ti19863a
Repair
Installation
1.Hold rebuild kit (15) and insert wobble drive into pis- ton pocket and connect together.
15
ti19642a
2. Install four bolts (21). Torque to 60
21
ti19643a
3.Install accumulator (16). Torque to 140
(15.8 N•m). Apply thread sealant to prime valve (17) and install. Torque to 140
16
18 | 17 |
ti19644a
4.Install inlet valve to pump module. See Inlet Valve, page 7.
5.Install outlet valve to pump module. See Outlet Valve, page 29.
6.Install pump module to drive module. See Pump Module/Drive Module, page 31.
32 | 3A2308C |
