Operation
5.If yellow light is flashing while triggering, pressure is set too high. You MUST turn down pressure until yellow light no longer flashes, increase tip size, or do not thin material as much.
6.If pressure relief valve is vibrating, pressure is set too high. You MUST turn down pressure, increase tip size, or do not thin material as much.
ti19655a
ti19656a
ti19654a
ti19653a
NOTE: Thin materials will generally require a low setting and thick materials will generally require a high setting.
IMPORTANT!
After storage, the piston seals need to be energized prior to next use to prevent leakage. To energize, follow steps below:
1.Prime system with flushing fluid.
2.Spray at low pressure setting “1” for 10 seconds.
3.Drain fluid. You are now ready to spray.
3A2308C | 11 |
