3.Set motor housing into right half of clamshell and loosely install two bolts (42) to motor housing as shown below.
42
Repair
7.Install ground terminal to stud and tighten second nut onto stud. Install wire up along handle.
ti19629a
4. Route wires from motor down the handle.
ti19630a
5.Assemble trigger over top of wires. Route trigger wires behind trigger.
ti19631a
6. Insert trigger lock over trigger with
ti19632a
ti19641a
8.Insert static wick into right half of clamshell and install left clamshell to right clamshell.
ti19634a
NOTICE
Wires can become damaged when pinched between clamshell halves. Make sure no wires are pinched during reassembly.
9.Install two bolts (42) to motor housing and install screws (43) to connect clamshell halves. Make sure LED lights and static wick are securely in place. Tighten bolts (42) to 50
43
42
ti19635a
10.Install pump module into drive module. See Pump Module/Drive Module, page 31.
36 | 3A2308C |
