...,-.,"'

u'r:a"tions

c1:"",,,-,.:':.i .~,;~~~~~(

This equipment complies with Parts 15 and 68 of the Federal Communications Commission (FCC) rules for the United States. It also complies with regula- tions RSS21O and CS-O3 of Industry and Science Canada. Operation is subject to the following two conditions: ( 1) this device may not cause interjer- ence, and (2) this device must accept any interference. including interfer- ence that may cause undesired opera- tion of the device.

A label is located on the underside of the base unit contairing either the FCC

registration number and Ringer Equivalence Number (REN) or the Industry Canada (IC) registration number and Load Number. You must, upon request, provide this information to your local telephone company.

-@-This equipment is compatible with inductively coupled hearing aids.

Should you experience trouble with this telephone equipment, please contact:

AUDIOVOX COMMUNICATIONS

SERVICE DEPT. at (800) 229-1235.

For repair/warranty information. The telephone company may ask you to disconnect this equipment from the line network until the problem has been corrected.

FCC Part 15

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliances could void the user's authority to operate the equipment.

The equipment has bee"n tested and found to comply with part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment gener- ates, uses and can radiate radio frequency energy and, it ~ot installed and used in accordance with the instructions, may cause harmful inter- terence to radio communications.

However, there is no guarantee that interference will not occur in a particu- lar installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between- the equipment and receiver. Connect the equipment into an outlet or on a circuit different from that to which the receiver is con- nected.

Consult the dealer or an experi- enced radio/TV technician for help.

-@-

I

4

OT94102.p65

4

~

6/24/98. 12:19 PM

-~-

II

Page 6
Image 6
Audiovox DT 941 CI manual Urations