Audiovox XMCK10AP manual Basic Operation, Turning Xpress ON and OFF, Active Channel Screen

Models: XMCK10AP

1 42
Download 42 pages 45.92 Kb
Page 12
Image 12
BASIC OPERATION

BASIC OPERATION

With the Xpress XM7 unit properly installed, activated and con- nected to your home/vehicle audio system or boom box, pro- ceed as follows:

Turning Xpress ON and OFF

Set up your Audiovox Xpress XM7 unit using the installation instructions included in this Kit (Home Kit, or Boom Box Kit), or with the help of a professional installer.

NOTE: Refer to Antenna Aiming during the installation pro- cedure.

Press the Power button to turn the unit ON. When the unit turns ON the XM7 logo will appear for 3-seconds (curved lines on either side of the XM7 logo gradually appear) (see Figure 4) followed by the Audiovox logo. These screens will be followed by the active channel (see Figure 5), which defaults to the last tuned channel setting prior to power being turned OFF. When the unit is shut OFF the XM logo will appear and the curved lines on either side of the XM7 logo gradually disappear.

NOTE: If this is the first time using the Xpress XM7 unit, the screen will alternately display the preview channel screen and

anumber of messages, including: “Activate Your XM7 1-800- XM RADIO”. If not, go to channel 1 using the Rotary/Select Knob on the Xpress XM7 unit or the CH Up/Down buttons on the remote control.

Figure 4. XM and Audiovox Logo Power ON Screen
Figure 5. Active Channel Screen

-12-

Page 12
Image 12
Audiovox XMCK10AP Basic Operation, Turning Xpress ON and OFF, XM and Audiovox Logo Power ON Screen, Active Channel Screen