AS
AUTOSTART TECH TOOL
5. OBDII SCAN BUTTON
Once the
Do not use the OBDII cable with any apparatus other than the Autostart’s
Please use the proper cable (see Fig. 3).
Warning: When erasing OBD II codes, some vehicles delete the memory bank used for fuel economy and anti pollution. We recommend that the user gets from the manufacturer all the required information before erasing OBD II codes.
6. REMOTE BUTTON
The “REMOTE” button provides 5 options:
Please use the proper cable (see Fig. 2).
1.“LEARN NEW REMOTE” makes it possible for the user to learn a new transmitter without having to go through the regular programming mode. Follow the instructions displayed to learn a new transmitter.
2.“USE REMOTE” allows the use of an already learned transmitter to test and operate the remote starter without having to unplug the antenna from the PRG- 1000. To use this function, follow the instructions displayed. (Note: A
3.“ERASE ALL REMOTES” erases, at once, all existing transmitter codes from the unit. Follow the instructions displayed to delete all transmitters from the remote starter’s memory.
4.“# REMOTE LEARNED” identifies the number of transmitters that are coded in the remote starter or alarm. Follow the instructions displayed to view how many transmitters are programmed into the unit.
5.“TEST REMOTE BUTTON” allows the user to test the transmitter’s operations. Establish which generation of remote (1ST generation
AS
AUTOSTART TECH TOOL
10. WRITE BUTTON
The “WRITE” button is used to save the programming changes to the unit’s processor. In order to avoid the unit’s EEPROM corruption, do not disconnect the
Please use the proper cable (see Fig. 2).
•Press “ENTER” followed by “WRITE” to store the unit’s new settings. The
11.RECALL BUTTON
The “RECALL” button allows the installer to recall customized settings of specific models for future units programming. Installers can recall and save up to 10 customized settings.
Please use proper the cable (see Fig. 2)
1.Press “RECALL”.
2.Select the file containing the customized settings you wish to review or apply.
3.Review the settings or press “WRITE” to program them into the unit’s processor.