AS
AUTOSTART TECH TOOL
9. READ BUTTON
The “READ” button displays the remote starter’s information and allows modification of its options.
Please use the proper cable (see Fig. 2).
1.Press “READ” and select one of the brand names displayed on the
2.Select the programming “Mode” you wish to access by scrolling “UP” or “DOWN” and pressing “ENTER”. You can always return to the previous menu by pressing “EXIT”.
3.Select the programming “Function” you wish to access by scrolling “UP” or “DOWN” and pressing “ENTER”. You can always return to the previous menu by pressing “EXIT”.
4.Select the programming “Option” you wish to change by scrolling “UP” or “DOWN” and pressing “ENTER”.
5.At that moment you can either immediately save the newly entered setting by pressing “ENTER” followed by “WRITE”, or wait until all changes are made and then press “WRITE” to save the new settings all at once to the remote starter.
6.Press “SAVE” to save the new settings to the
Warning: Modifications made to the customizable options will apply solely when writing to the remote starter EEPROM is completed. Never disconnect the AS
AS
AUTOSTART TECH TOOL
7. DIAGNOSTIC BUTTON
The “DIAG” button is used to troubleshoot units. It offers 3 options:
Please use the proper cable ( see Fig. 2).
1.“START FAILURE” displays the last recorded remote start failure.
2.“LAST ALARM” displays the last event that generated a full alarm trigger.
3.“ERASE START FAILURE” deletes the last stored remote start failure.
8.FUNCTION BUTTON
The “FUNCT” button is used to reset a unit to its factory settings, or to erase all of the installer’s programming files.
Please use the proper cable( see Fig. 2).
1.“RESET STARTER” clears all previous settings, events loggings, tachometer references and transmitter codes stored in the unit, and resets them to the factory settings. After selecting “RESET STARTER”, you are prompted to confirm your choice by pressing “ENTER”. If you do not wish to reset the unit completely, press “EXIT” to go back to the preceding menu.
2.“RESET
