USER INSTRUCTIONS
GENERAL INFORMATION
WARNING!!
1.This appliance shall not be used for space heating. This information is based on safety considerations.
2.AlI openings in the wall behind the appliance and in the floor under the appliance shall be sealed.
3.Keep appliance area clear and free from combustible materials, gasoline, and other flammable vapors.
4.Do not obstruct the flow of combustion and ventilation air.
5.Disconnect the electrical supply to the appliance before servicing.
6.When removing appliance for cleaning and/or service;
A.Shut off gas at main supply.
B.Disconnect AC power supply.
C.Disconnect gas line to the inlet pipe.
D.Carefully remove the range by pulling outward. CAUTION: Range is heavy; use care in handling.
WARNING!!
ELECTRICAL GROUNDING INSTRUCTIONS
The range must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA No.
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE PROPERLY GROUNDED.
If an external electrical source is utilized, the installation must be electrically grounded in accordance with local codes or, in the absence of local codes, with the national Electrical Code, ANSI/NFPA 70.
REPLACEMENT PARTS
Only authorized replacement parts may be used in performing service on the range. Replacement parts are available from factory authorized parts distributors. Contact the nearest AVANTI parts distributor in your area.
7.Electrical Requirement
Electrical installation should comply with national and local codes.
8.Air Supply and Ventilation
The installer must refers to local/national codes.
9.Gas Manifold Pressure
Natural gas - 4.0” W.C.P. LP/Propane - 11.0” W.C.P.
10.The misuse of oven door (e.g. stepping, sitting, or leaning on them) can result in potential hazards and/or injuries.
11.When installing or removing the range for service, a rolling lift jack should be used. Do not push against any of the edges of the range in an attempt to slide it into or out of the installation. Pushing or pulling a range (rather than using a lift jack) also increases the possibility of bending the leg spindles or the internal coupling connectors.
4
