Connect the cables, Connect the console cable, Avaya P333T LEDs

Connect the cables

1.Connect the Ethernet connection cable (not supplied) to a 10/100 Mbps port on the front panel of the Avaya P330.

!You should use standard RJ-45 connections. You must use CAT-5 cable for 100 Mbps operation.

2.Connect the other end of the cable to the Ethernet port of the PC, server, router, worksta- tion, switch or hub.

!Use a cross cable when connecting the Avaya P330 to a switch or hub.

3.Check that the appropriate link (LNK) LEDs light up.

1.Configure the serial port settings of the PC or terminal as follows: Baud Rate – 9600, Parity

– no, Data bits – 8, Stop bits – 1, Flow control – no.

2.Connect the supplied special RJ-45 connector to the port marked “Console” on the front panel of the Avaya P330.

3.Connect the other end of the cable to a terminal or PC with terminal emulation software installed.

FIV switch Function LEDs

FIV – Force Initial Version (see Avaya P330 User’s Guide)

LNK – When ON, link is OK

COL – When ON, indicates a collision on the port in HDX mode

Tx, Rx – Shows traffic activity for transmitted and received packets FDX – Shows Full/Half Duplex mode

FC – When ON, Flow Control is enabled for a port in FDX mode

Hspd – Shows speed of port (10 Mbps or 100/1000 Mbps)

LAG – When ON, the port is included in a Link Aggregation Group (LAG).

ROUT – Shows switch’s mode of operation SYS – Shows whether this module is the Avaya P330 Stack Master agent

OPR – Shows CPU boot status PWR – Shows when power is on