AVERATEC 3200 Change User Password, Change Supervisor Password, Auto Configuration with Optimal Settings, Exiting and Saving, Esc, Enter, Change Supervisor Password

Using the BIOS Setup Utility —Change User Password

Change User Password

With a User password, you can enter the Setup Utility and change or remove the User password, but you cannot enter the Setup Utility and change or remove the Supervisor password, nor enable diskette access if it has been disabled.

Change Supervisor Password

A supervisor password must be set before a lower-level user password can be set. After selecting Change Supervisor Password, press Enter. You will be prompted for the new password, and then again to verify it. Type in 6 or fewer keystrokes. If you make an error, press Esc to start over.

Enter new supervisor password:

Auto Configuration with Optimal Settings

The Auto Configuration pages reset the computer to default values. The Auto Detect Hard Disks likewise helps users to configure their systems quickly. When you see the following prompt, choose Y to reset the computer to default values.

Load high performance settings (y/n)? N

Exiting and Saving

Save Settings	Select this option to save changes to the field
and Exit	values, and restart the computer using the new
	values. (Pressing F10 from any of the menu
	screens also allows you to save settings and exit.)
Exit Without	Select this option to discard any changes you have
Saving	made to the field values, and restart the computer
	using the old values.