Avocent DSR1030, DSR4030, DSR8030 Using Scan mode, To turn Broadcasting off:, To add target devices to the Scan list:

Chapter 3: Local Port Operation 27

To turn Broadcasting off:

From the Commands dialog box, clear the Broadcast Enable checkbox.

Using Scan mode

In Scan mode, the DSR switch automatically scans from port to port (target device to target device). You can scan up to eight target devices, specifying which ones to scan and the number of seconds that each will display. The scanning order is determined by placement of the target device in the list. The list is always shown in scanning order. You can, however, choose to display the target device’s name or EID number by pressing the appropriate button.

NOTE: Scanning is only available to the local user.

To add target devices to the Scan list:

1.If the OSCAR interface is not open, press Print Screen. The Main dialog box will appear.

2.Click Setup - Scan. The Scan dialog box appears.

Figure 3.11: Scan Dialog Box

3.Determine the order within the list to add the target device. If there are no target devices in the Scan list, your cursor will appear in a blank line at the top of the list.

-or-

To add a target device to the end of the list, place your cursor in the last target device entry and press the Down Arrow key.

-or-

To add a target device within an existing list, place your cursor in the line below where you want to insert a new target device and press Insert.