18DSR Installer/User Guide

3.Choose an available port on the rear of your DSR1021 switch. Plug one end of a CAT 5 cable (4-pair, up to 10 meters) into a numbered port and plug the other end into the RJ-45 connector of a DSRIQ module.

4.Plug the DSRIQ module into the appropriate ports on the back of the server. Repeat this procedure for all servers that are to be connected to the DSR1021 switch.

5.Plug a CAT 5 cable from your Ethernet network into the LAN connector on the back of your DSR1021 switch. Network users will access the DSR appliance through this port.

6.(Optional) The DSR1021 switch may also be accessed using a ITU V.92, V.90 or V.34-compatible modem. Plug a 9-pin serial cable into the MODEM connector on the back of your DSR1021 switch. Plug the other end into the connector on the back of the modem.

NOTE: Using a modem connection instead of a LAN connection will limit the performance capability of your DSR1021 switch.

7.(Optional) Plug one end of the cable supplied with the SPC power control device into the SPC connector on the DSR1021 switch and plug the other end into an SPC device. Plug the power cords from the target servers into the SPC device power outlets. Plug the SPC device into an appropriate AC wall outlet.

8.Power up each target server and then power up the DSR1021 switch.

To install your DSR software:

See the DSView Installer/User Guide that ships with your software.

NOTE: Your software registration key will be necessary for installing the DSAuth Server used with your DSR1021 switch.