8/16/32 PS/2 KVM over IP switch
19
Figure4-1. PS/2 IP-KVM switch setup tool
On the upper left corner, the MAC address of the PS/2 IP-KVM switch is displayed. To detect
the MAC address, manually, press the button “Refresh Devices”. The displayed MAC address
is the same MAC address printed on the white sticker placed on the back of the PS/2 IP-KVM
switch. If the PS/2 IP-KVM switch is connected via USB, it is classified as an USB device and
an appropriate drive letter is chosen for this device.
On the lower right corner of the window, there are two buttons: “Query Device” and “Setup
Device“. Press the “Query Device” button to display the preconfigured values of the network
configuration. The values are displayed in the text fields located above. If necessary, adjust the
network settings to your needs. To save the changes, press the “ Setup Device ” button.
Authentication
To adjust the authentication settings, enter your login as a super user, and change your
password.
Super user login
Enter the login name of the super user. The initial value is “ super ”. All of characters are
lower case.
Super user password
Enter the current password for the super user. This initial value is “ pass “. All of characters
are lower case.
New super user password
Enter the new password for the super user.
New password (confirm)
Re-type the new password for the super user.
To close the window and accept the changes, press the “ OK ” button, otherwise press the
“ Cancel ” button.