32 AXIS 207/207W - System Options
RTSP
The RTSP protocol allows a connecting client to start an MPEG-4 stream. Enter the RTSP
port number to use. The default setting is 554.
Network Traffic
Connection Type - The default setting is Auto-negotiate, which means that the correct
speed is automatically selected. If necessary, you can set the connection speed by selecting
it from the drop-down list.
For more information, please see the online help.
Wireless (AXIS 207W only)
These settings should always be made in the camera first and secondly in the wireless
access point. This ensures that the camera is always accessible when making changes.
Using a wired connection ensures greater secrecy while making these settings.
Status of Wireless Networks
This list is the result of a network scan. Access points with a disabled SSID Broadcast will
not appear unless the camera is associated with it. The network currently associated to is
shown in blue. A network using unsupported security is shown in grey. The following
information is provided:
• SSID - The name of a wireless network (or ad-hoc device) . If the s ame nam e occurs severa l
times this means that several access points for that network were found. The AXIS 207W
cannot be configured to only associate with one particular access point.
• M ode - The Access Point (Master) or Ad-Hoc device.
• Security - Shows which type of security the network uses. See below for the security types
supported by the AXIS 207W.
• Channel - Shows the wireless channel currently in use.
• Signal strength - Shows the signal strength.
• Bit rate - Shows the bit rate in Mbit/s. This can only be shown for the access point
currently in use. Note that the bit rate shown is the current rate, and that this value may
vary over time.
Wireless Settings
These settings control how the AXIS 207W interacts with the wireless network. Apart from
identifying the wireless network, it is also possible to enable wireless encryption.
SSID - This is the name of the wireless network the AXIS 207W is configured for. The field
accepts up to 32 alphanumeric characters. The name must be exactly the same as that used
in the wireless access point, or the connection will not be established.