Axis Communications 210/211 user manual Symptoms, Possible Causes and Remedial Actions

46AXIS 210/211 - Troubleshooting

Symptoms, Possible Causes and Remedial Actions

Problems setting the IP address
	When using ARP/Ping.	Try the installation again. The IP address must be set within two minutes after power has
		been applied to the camera. Ensure the Ping length is set to 408. See the Installation
		Guide.
	The camera is located on a different	If the IP address intended for the camera and the IP address of your computer are located
	subnet.	on different subnets, you will not be able to set the IP address. Contact your network
		administrator to obtain an appropriate IP address.
	The IP address is being used by another	Disconnect the camera from the network. Run the Ping command. (In a Command/DOS
	device	window, type ping and the IP address of the unit).
		If you receive: Reply from <IP address>: bytes = 32; time = 10 ms..... - this means that
		the IP address may already be in use by another device on your network. You must obtain
		a new IP address and reinstall the unit.
		If you see: Request timed out - this means that the IP address is available for use with
		your camera. In this case, check all cabling and reinstall the unit.
	Possible IP address conflict with	The static IP address in the camera is used before the DHCP server sets a a dynamic
	another device on the same subnet.	address. This means that if the same default static IP address is also used by another
		device, there may be problems accessing the camera. To avoid this, set the static IP
		address to 0.0.0.0.
The	camera cannot be accessed from a browser
	The IP address has been changed by	1) Move the camera to an isolated network or to one with no DHCP or BOOTP server. Set
	DHCP.	the IP address again, using the AXIS IP Utility (see the Installation Guide) or the ARP/Ping
		commands.
		2) Access the unit and disable DHCP in the TCP/IP settings. Return the unit to the main
		network. The unit now has a fixed IP address that will not change.
		3) As an alternative to 2), if dynamic IP address via DHCP or BOOTP is required, select the
		required service and then configure IP address change notification from the network set-
		tings. Return the unit to the main network. The unit will now have a dynamic IP address,
		but will notify you if the address changes.
	Other networking problems.	Test the network cable by connecting it to another network device, then Ping that device
		from your workstation. See the instructions above.
Cannot send notifications, uploads, alarms,		etc, to a destination outside the local network
	Firewall protection.	The camera can be configured to use a SOCKS server to reach networks on the other side
		of a firewall/proxy server.
Camera is accessible locally, but not externally
	Firewall protection.	Check the Internet firewall with your system administrator.
	Default routers required.	Check if you need to configure the default router settings.