52AXIS 241Q/241S - Unit connectors

Y/C to BNC cable

AXIS 241Q/241S supports conversion from Y/C (S-video) to composite video using an Y/C to BNC cable. The cable is available as an accessory - see the Axis Web site at: www.axis.com. Follow these instructions to connect the Y/C to BNC cable:

1.Connect the BNC connector marked IN to the Video In connector on the video server.

2.Connect the BNC connector marked OUT to the Video OUT connector on the video server.

3.Connect the Y/C connector to the Y/C video unit (S-video).

4.Set the DIP switches on the front panel of the unit to 1=ON, 2=ON, 3=OFF, 4=OFF.

5.Go to AXIS 241Q/241S web pages under Setup > Video & Image > Video Source and select Y/C (S-video) from the Physical connector drop-down list.

One female MiniDin 4-pol connector

split into two BNC connectors

Below is a description of how the cable can be assembled using standard components:

1.Use two male BNC connectors and one female 4-pole MiniDin connector.

2.Connect pin 1, 2 and shield on the MiniDin connector to the shield on the two BNC connectors.

3.Connect pin 3 (Y) on the MiniDin connector to centre pin on one of the male BNC connectors, mark this BNC connector with IN.

4.Connect pin 4 (C) on the MiniDin connector to centre pin on the other male BNC connector, mark this BNC connector with OUT.

The pins on the

MiniDin connector

Page 52
Image 52
Axis Communications 241Q user manual To BNC cable