8AXIS 241Q/241S - Product description

Switches & connectors

DIP switch (AXIS 241Q) - A corresponding line termination switch is supplied for each video input. All units are shipped with line termination enabled for each video input, that is, with the DIP switch set in the down position.

DIP switch (AXIS 241S) - Upon delivery the dip switch on the AXIS 241S is configured for composite video input, as follows:

Switch

1

2

3

4

 

 

 

 

 

Description

75 ohm video in

75 ohm video out

Connects video in and

Not used

termination

termination

video out

 

 

 

 

 

 

 

 

Composite video input

on

off

on

n/a

 

 

 

 

 

Y/C video input

on

on

off

n/a

 

 

 

 

 

Note: If the video source is to be connected in parallel with other equipment, disable the input termination by turning the corresponding DIP switch to the up position (OFF). Failure to do so may cause reduced image quality.

Control Button - Press this button to restore the factory default settings, as described in Resetting to the factory default settings, on page 48, or to install the video server using AXIS Internet Dynamic DNS Service (See the Axis Video Server Installation Guide).

Video Input - The video input is connected using a coax/BNC connector. Physical connections made using 75 ohm coaxial video cable have a recommended maximum length of 800 feet (250 meters).

Video Output (AXIS 241S only) - Loopthrough connection to the video signal from the Video In connector. Terminated with a coaxial/BNC connector. Allows direct connection of an external monitor for example. Set DIP switch to ON when in use.

Rear panel

12-pin I/O terminal

Network

RS-232

connector

connector

 

connector

 

 

Power adapter connector

Serial number on underside label

Power adapter connector - Connect the power adapter.

Page 8
Image 8
Axis Communications 241Q user manual Switches & connectors, Rear panel, Switch Description, Video input