AXIS 207/207W/207MW Installation Guide | Page 7 |
3.Install the hardware
!IMPORTANT! - The AXIS 207/207W/207MW is designed for indoor use only, and must always be positioned where it is not exposed to direct sunlight or strong halogen light, which can cause permanent damage to the camera’s image sensor. Damage as a result of exposure to strong light is not covered by the Axis warranty.
3a. Mount the camera
Make a note of the serial number (S/N) located on the product label. This number may be required during installation.
Wall mounting
1.If required, use the 3 supplied screws to fix the base plate to a flat (horizontal or vertical) surface.
2.To use a shorter stand, unscrew the lock ring to release the camera, and remove the extension section.
3.Attach the camera, adjust the angle and tighten the lock ring.
Shelf mounting
1.Position the clamp and tighten the fixing screw securely.
2.Attach the clamp to the lock ring on the camera.
3.Adjust the angle and tighten the lock ring.
3b. Connect the cables
1.Using the
clip to the rear panel and fasten the power cable to it. This will prevent accidental cable disconnection.
2.Connect the camera to the network using a shielded network cable. For the wireless models, this connection is temporary and allows the camera’s settings to be configured via the wired network before connecting to the wireless network.
3.Optionally connect external devices, e.g. alarm devices. See page 5 for information on the terminal connector pins.
4.Connect power, using one of the methods listed below:
•Connect the supplied indoor power supply to the power connector on the camera.
•Connect power via the terminal connector. See page 5 for information on the ter- minal connector pins.
5.Check that the indicator LED:s indicate the correct conditions. See the table on page 6 for further details. Note that some LED:s can be disabled and may be unlit.
ENGLISH
