Axis Communications M3007-P Setup Live View Config and select Java applet under Default viewer

AXIS M3007–P

Troubleshooting

No H.264 displayed in the	Check that the relevant H.264 connection methods and correct interface are enabled in the AMC
client	Control Panel (streaming tab). See AXIS Media Control (AMC), on page 12.
	In the AMC Control Panel, select the H.264 tab and click Set to default H.264 decoder.
	Check that RTSP is enabled under System Options > Network > TCP/IP > Advanced.
Multicast H.264 only	Check if your router supports multicasting, or if the router settings between the client and the
accessible by local clients	product need to be configured. The TTL (Time To Live) value may need to be increased.
No multicast H.264	Check with your network administrator that the multicast addresses used by the Axis product
displayed in the client	are valid for your network.
	Check with your network administrator to see if there is a firewall preventing viewing.
Installation of additional	Configure the Axis product to use a Java applet for updating video images in your browser. Go to
ActiveX component	Setup > Live View Config and select Java applet under Default viewer.
restricted or prohibited
Poor rendering of H.264	Ensure that your graphics card is using the latest driver. The latest drivers can usually be
images	downloaded from the manufacturer’s website.
Color saturation is different	Modify the settings for your graphics adapter. Refer to the adapter’s documentation for more
in H.264 and Motion JPEG	information.
Lower frame rate than	See Performance Considerations, on page 58.
expected	Reduce the number of applications running on the client computer.
	Limit the number of simultaneous viewers.
	Check with the network administrator that there is enough bandwidth available.
	Check in the AMC Control Panel (H.264 tag) that video processing is NOT set to Decode only
	key frames.
	Lower the image resolution.
	The maximum frames per second is dependent on the utility frequency (60/50 Hz) of the Axis
	product. See Technical Specifications, on page 56.
Video and image problems, general
Image unsatisfactory	Check the video stream and camera settings under Setup > Video > Video Stream and Setup >
	Video > Camera Settings.
Disturbed focus	Set the focus manually by turning the focus ring. See Hardware Overview, on page 5
Motion Detection triggers unexpectedly
Changes in luminance	Motion detection is based on changes in luminance in the image. This means that if there are
	sudden changes in the lighting, motion detection may trigger mistakenly. Lower the sensitivity
	setting to avoid problems with luminance.
Storage and disk management problems
Video cannot be recorded	Check that the SD card is not write protected (that is, read only).
SD card cannot be mounted	Reformat the SD card and then click Mount.

55