Install the pop-up drain
•Remove the plunger assembly.
•Unscrew the drain outlet flange from the tee.
•Unscrew the tailpiece from the tee. Wrap the threads with plumbers’ thread tape and replace.
•Install the white, flexible sealing gasket to the flange. Sit it in the sink outlet.
•From under the sink, install the black mack gasket, white friction ring , and retainer nut to the flange. Do not tighten the nut against the bottom of the sink at this time.
•Thread the tee and tailpiece to the flange. The pivot must face the faucet. If necessary, turn the drain assembly.
•Tighten the retainer nut.
•Sit the plunger assembly in the drain.
•Install the horizontal rod so that the end goes through the loop in the bottom of the height adjuster.
•Install and hand tighten the pivot ball nut.
•Attach the swivel connector to the end of the horizontal rod.
•Attach the swivel connector to the end of the vertical rod. Position as desired, and tighten with a small, flathead screwdriver.
plunger
plunger assembly 
height adjuster
drain outlet flange 
sealing gasket 
mack gasket 
friction ring
retainer nut
tee
pivot ball nut
horizontal rod |
swivel connector |
5
