Customization and
Configuration
The MX-R power amplifier is configured from the factory for flexible operation in most audio systems. However, in certain installations it may be desirable to change the factory default settings or create an alternate control connection.
Display Brightness
Normally the brightness of the status LED is controlled by other linked components connected to the MX-R via the AyreLink communications port. However if there are no other AyreLink components available, the brightness level may be set while in the configuration mode.
To enter the configuration mode, make sure that the amplifier has been disconnected from the AC mains power for at least one minute. Then press and hold the front-panel button while plugging the power back in. The status LED will flash violet to indicate the amplifier is in configuration mode.
The unit will remain in configuration mode for ten seconds. During that time, pressing the front-panel button will change the default setting for the brightness of the status LED as noted below:
