Pengo Computer Accessories UBR7200 Pppoe tag, Enable PPPoE forwarding on the radio interface

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

pppoe tag

pppoe tag

To assign a qos-level tag for packet from a particular SU so that the packet is forwarded to a particular virtual circuit, use the tag global configuration command. To disable the tag specification, use the no form of this command.

tag string qos-level level-numtype {pppoe all [sid-index]}no tag string qos-level level-numtype {pppoe all [sid-index]}

Syntax Description	String	Specifies the tag name to be used.
	qos-level level-num	Specifies QoS level number to map to a virtual circuit (VC). The range for
		level-numis 1 to 1024.
	type {pppoe all}	Specifies packet fowarding options as either pppoe or all.
	pppoe	Specifies that only pppoe packets are allowed to forwarding.
	all	Specifies that all packets are allowed to forwarding.
	sid-index	Creates service identifier index in an internal table.

Defaults

Command Modes

Command History

Examples

No default behaviors or values.

Global configuration

ReleaseModification

12.1(3)XQ1 This command was introduced.

In the following example, all PPPoE packets arriving from an SU previously registered with SU tag “UunNet-Gold" are assigned qos-level1:

Router(config)# tag UUNet-Gold qos_level 1 type pppoe

Related Commands	Command	Description
	pppoe-forwarding	Enable PPPoE forwarding on the radio interface.
	forwarding	Set all packets received on the radio interface with a single
	default-qos-level	quality-of-service (QoS)-level.
	forwarding group	Sets a PPPoE forwarding group number on the radio interface.
	su-mac	Specifies the subscriber unit MAC address that is mapped from the radio
		interface to the virtual circuit (VC) on the ATM interface for PPPoE
		forwarding.

Cisco IOS Release 12.1(5)XM

34