Pengo Computer Accessories UBR7200 manual Radio interface radio hist-stop

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

radio interface radio hist-stop

radio interface radio hist-stop

To stop a running histogram specification, use the radio interface radio hist-stopEXEC command.

radio interface radio slot/port hist-stopstatsParams {MAC-address chan-id}

Syntax Description

Defaults

slot/port	Specifies the slot and port numbers.
statsParams	{sinr-ant1 sinr-ant2 sinr-total timingOffset rf-rx-power-ant1
	rf-rx-power-ant2 chan-delay-spread-ant1 chan-delay-spread-ant2
	power-amb}
sinr-ant1	Signal-to-interference plus noise ratio for antenna 1.
sinr-ant2	Signal-to-interference plus noise ratio for antenna 2.
sinr-total	Signal-to-interference plus noise ratio for antennas 1 and 2.
timingOffset	Represents the timing delay variations detected in the radio link.
rf-rx-power-ant1	Represents the receive power at the main RF headend (antenna gain is not
	included).
rf-rx-power-ant2	Represents the receive power at the diversity RF headend (antenna gain is
	not included).
chan-delay-spread-ant1The offset for channel delay spread on antenna 1.
chan-delay-spread-ant2The offset for channel delay spread on antenna 2.
power-amb	Represents the noise floor of the ambient environment, in decibels.
MAC-address	Specifies a particular subscriber unit.
chan-id	Specifies an upstream channel ID. Valid values are 0 to 3.

No default behavior or values.

Command Modes

Command History

EXEC

ReleaseModification

12.1(3)XQ1 This command was introduced.

Examples	The following example shows how to stop a running histogram specification for sinr-ant1on channel 0:
	Router# radio int r6/0 hist-stop sinr-ant 0

Cisco IOS Release 12.1(5)XM

60