Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

radio threshold

 

 

clear-time

Identifies how long the signal stays below a threshold before another event

 

 

 

is generated.

 

 

 

 

 

 

dsp

Specifies one of the following digital signal process (DSP) numbers

 

 

 

(dspNum): dsprx0, dsprx1, dsprx2, or dsprx3.

 

 

 

 

 

 

 

Defaults

 

No default behavior or values.

Command Modes

Command History

Interface configuration

ReleaseModification

12.1(3)XQ1

This command was introduced.

 

 

Usage Guidelines The following describes how clear-timeand repeat-timework for the three scenarios:

1.If clear-timeis any value and repeat-timeis 0, the user is notified whenever one of the following threshold conditions are met: {high-thresh low-thresh up-change down-change pos-crossing neg-crossing}.

2.If clear-timeis greater than 0 and repeat-timeis 0, the following occurs:

a.When a threshold condition is met for the first time, the user is notified.

b.When a threshold condition does not occur for the length of clear-time, the user is notified and the cycle continues with Step 2a.

3.If both clear-timeand repeat-timeare greater than 0, the following occurs:

a.When one of the threshold conditions occurs for the first time, the user is notified. After the first notification, no more notifications are sent for the length of repeat-time. At the end of repeat-time, the user is notified indicating how many times the user was not notified when the threshold condition occurred.

b.When a threshold condition stops being met for the length of clear-timeperiod, the user is notified then the cycle starts with Step 3a.

Examples

 

The following example configures threshold specification for sinr-ant1on channel 0:

 

 

Router(config-if)#radio threshold sinr-ant1 0 high 30

 

 

 

 

Related Commands

 

Command

Description

 

 

 

 

 

 

show interface radio

Displays the set of currently configured thresholds on the radio card.

 

 

thresholds

 

 

 

 

 

Cisco IOS Release 12.1(5)XM

97

Page 97
Image 97
Pengo Computer Accessories UBR7200 manual Dsp, Routerconfig-if#radio threshold sinr-ant1 0 high