Pengo Computer Accessories UBR7200 manual Show interface radio tl-spec, Port, 141

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

show interface radio tl-spec

show interface radio tl-spec

To display the details of the currently-configured timeline specifications, use the show interface radio tl-specprivileged EXEC command.

show interface radio slot/port tl-spec[statsParams {MAC-address chan-id}]

Syntax Description

Defaults

Command Modes

Command History

slot/port	The slot and port numbers of the radio card.
statsParams	{sinr-ant1 sinr-ant2 sinr-total timingOffset rf-rx-power-ant1
	rf-rx-power-ant2 chan-delay-spread-ant1 chan-delay-spread-ant2
	power-amb}
	The data for the radio attribute is collected as a histogram.
sinr-ant1	Signal-to-interference plus noise ratio for antenna 1.
sinr-ant2	Signal-to-interference plus noise ratio for antenna 2.
sinr-total	Signal-to-interference plus noise ratio for antennas 1 and 2.
timingOffset	Represents the timing delay variations detected in the radio link.
rf-rx-power-ant1	Represents the receive power at the main RF headend (antenna gain is not
	included).
rf-rx-power-ant2	Represents the receive power at the diversity RF headend (antenna gain is
	not included).
chan-delay-spread-ant1The offset for channel delay spread on antenna 1.
chan-delay-spread-ant2The offset for channel delay spread on antenna 2.
power-amb	Represents the noise floor of the ambient environment, in decibels.
MAC-address	Specifies the MAC address for a particular subscriber unit.
chan-id	Specifies an upstream channel ID.

No default behavior or values.

Privileged EXEC

ReleaseModification

12.1(3)XQ1 This command was introduced.

Examples	The following example shows how to display the timeline specification for the radio card in slot 6,
	port 0:
	Router# show int radio 6/0 tl-spec

Cisco IOS Release 12.1(5)XM

141