Pengo Computer Accessories UBR7200 manual Radio hist-display

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

radio hist-display

radio hist-display

To control the display of histogram data, use the radio hist-displayinterface configuration command.

radio histogram {[all] {statsParams MAC-address chan-id}on off}

Syntax Description

Defaults

all	Controls the display of all the histograms in the system.
statsParams	{sinr-ant1 sinr-ant2 sinr-total timingOffset rf-rx-power-ant1
	rf-rx-power-ant2 chan-delay-spread-ant1
	chan-delay-spread-ant2 power-amb}
sinr-ant1	Signal to interference plus noise ratio for antenna 1.
sinr-ant2	Signal to interference plus noise ratio for antenna 2.
sinr-total	Signal to interference plus noise ratio for antennas 1 and 2.
timingOffset	Represents the timing delay variations detected in the radio link.
rf-rx-power-ant1	Represents the receive power at the main RF headend (antenna gain
	is not included).
rf-rx-power-ant2	Represents the receive power at the diversity RF headend (antenna
	gain is not included).
chan-delay-spread-ant1	The offset for channel delay spread on antenna 1.
chan-delay-spread-ant2	The offset for channel delay spread on antenna 2.
power-amb	Represents the noise floor of the ambient environment, in decibels.
MAC-address	Specifies a particular subscriber unit.
chan-id	Specifies an upstream channel ID. Valid values are 0 to 3.
on off	Specifies whether to turn the display of the histogram data on or off.

By default the histogram display is on.

Command Modes

Command History

Interface configuration

Release	Modification
12.0(7)XR	This command was introduced.
12.1(3)XQ1	Support for multipoint radio modem was added.

Examples	The following example shows how to set the display of histogram data for sinr-ant1on channel 0 to
	OFF:
	UBR04(config-if)#radio hist-display sinr-ant1 0 off

Cisco IOS Release 12.1(5)XM

50