Pengo Computer Accessories UBR7200 manual Radio histogram

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

radio histogram

radio histogram

To configure a histogram collection specification, use the radio histogram interface configuration command. To delete existing histogram collections, use the no form of this command.

radio histogram statsParams {MAC-address chan-id}[bin-range{start end}] [duration interval] [tone {circular average number toneVal}] [update interval sum {true false}] [width {coarse fine}]

no radio histogram statsParams {MAC-address chan-id}

Syntax Description	statsParams	{sinr-ant1 sinr-ant2 sinr-total timingOffset rf-rx-power-ant1
		rf-rx-power-ant2 chan-delay-spread-ant1
		chan-delay-spread-ant2 power-amb}
	sinr-ant1	Signal to interference plus noise ratio for antenna 1.
	sinr-ant2	Signal to interference plus noise ratio for antenna 2.
	sinr-total	Signal to interference plus noise ratio for antennas 1 and 2.
	timingOffset	Represents the timing delay variations detected in the radio link.
	rf-rx-power-ant1	Represents the receive power at the main RF headend (antenna gain
		is not included).
	rf-rx-power-ant2	Represents the receive power at the diversity RF headend (antenna
		gain is not included).
	chan-delay-spread-ant1	The offset for channel delay spread on antenna 1.
	chan-delay-spread-ant2	The offset for channel delay spread on antenna 2.
	power-amb	Represents the noise floor of the ambient environment, in decibels.
	MAC-address	Specifies a particular subscriber unit.
	chan-id	Specifies an upstream channel ID. Valid values are 0 to 3.
	bin-range start end	Specifies the start and end bin values. Values below the start bin
		values are assigned to the first bin in the histogram. Values above this
		value are assinged to the last bin in the histogram. Start and end bin
		values range -5000 to 5000. The following values are default start and
		end bin range values:
		sinr-ant1: {10, 49}
		sinr-ant2: {10, 49}
		sinr-total: {10, 49}
		timingOffset: {-10, 10}
		rf-rx-power-ant1:{-86,-43}
		rf-rx-power-ant2:{-86,-43}
		chan-delay-spread-ant1: {0, 4}
		chan-delay-spread-ant2: {0, 4}
		power-amb: {-101, -21}
	duration interval	Specifies, in seconds, the duration in which histogram data is
		collected.
	tone	{circular average number} are applicable only to sinr-ant1,
		sinr-ant2, and sinr-total.
	circular	Specifies histogram samples that use successive frequency tones.

Cisco IOS Release 12.1(5)XM

52