Pengo Computer Accessories UBR7200 manual Command Reference, Startup Commands

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

Command Reference

Command Reference

This section documents the new commands associated with the fixed wireless multipoint feature. All other commands used with this feature are documented in the Cisco IOS Release 12.1 command reference publications. The commands are classified into the following groups:

•Startup Commands

•Installation and Configuration Commands

•Verification Commands

•Operating Commands

•Monitoring Commands

•Troubleshooting Commands

Note This classification is created to help the user in chunking the commands. Some of the commands can be listed under any of these groups.

Startup Commands

Use the following commands to startup your fixed wireless multipoint headend system. Note that these commands are not specific to this feature; they are Cisco IOS generic commands, and their syntax can be found in the command reference documentation for Cisco IOS Release 12.1, available on CCO and the Documentation CD-ROM.

•show running-configuration

•show start-up configuration

•shut

•write

Installation and Configuration Commands

Use the following commands to install and configure your fixed wireless multipoint headend system:

•loopback

•microcode reload

•radio arp

•radio cable-loss

•radio downstream annex B

•radio downstream frequency

•radio downstream subchannel modulation-profile

•radio helper-address

•radio insertion-interval

•radio interface radio rf-update duplexer

•radio modulation-profile

•radio receive-antennas

Cisco IOS Release 12.1(5)XM

17