Pengo Computer Accessories UBR7200 Show interface radio hist-spec, Radio card in slot 6, port

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

show interface radio hist-spec

show interface radio hist-spec

To display histogram specifications, use the show interface radio hist-specEXEC command.

show interface radio slot/port hist-spec[statsParams {MAC-address chan-id}]

Syntax Description

Defaults

slot/port	Specifies the slot and port numbers of a wireless modem card.
statsParams	{sinr-ant1 sinr-ant2 sinr-total timingOffset rf-rx-power-ant1
	rf-rx-power-ant2 chan-delay-spread-ant1 chan-delay-spread-ant2
	power-amb}
sinr-ant1	Signal-to-interference plus noise ratio for antenna 1.
sinr-ant2	Signal-to-interference plus noise ratio for antenna 2.
sinr-total	Signal-to-interference plus noise ratio for antennas 1 and 2.
timingOffset	Represents the timing delay variations detected in the radio link.
rf-rx-power-ant1	Represents the receive power at the main RF headend (antenna gain is not
	included).
rf-rx-power-ant2	Represents the receive power at the diversity RF headend (antenna gain is
	not included).
chan-delay-spread-ant1The offset for channel delay spread on antenna 1.
chan-delay-spread-ant2The offset for channel delay spread on antenna 2.
power-amb	Represents the noise floor of the ambient environment, in decibels.
MAC-address	Specifies the MAC address for a particular subscriber unit.
chan-id	Specifies an upstream channel ID.

No default behavior or values.

Command Modes

Command History

EXEC

ReleaseModification

12.1(3)XQ1 This command was introduced.

Examples	The following example shows how to display the histogram specification for sinr-ant1on channel 0 for
	the radio card in slot 6, port 0:
	Router# show int radio 6/0 hist-spec sinr-ant1 0
Related Commands	Command	Description
	show interface radio	Displays histogram data.
	slot/port hist-data

Cisco IOS Release 12.1(5)XM

129