Pengo Computer Accessories UBR7200 manual Radio interface radio rf-update duplexer, Command Modes

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

radio interface radio rf-update duplexer

radio interface radio rf-update duplexer

To set or update the radio frequency or wireless transverter duplexer information stored in the hardware, use the radio interface radio rf-update duplexer privileged EXEC command.

radio interface radio slot/port rf-update duplexer {1 2} code-dateLo-bandStartLo-bandEndHi-bandStartHi-bandEndTx-insertion-loss[Tx-loTx-hi]

Syntax Description	slot/port	Identifies the slot and port numbers.
	1 2	Enter 1 for the main antenna or 2 for the diversity antenna.
	code-date	Identifies the date the duplexer information was last updated or reset. The
		date must be specified in the mmddyyyy format. For single digit month and
		date values, you need to zero-fill them. For example, for August 3, 2000,
		you enter 08032000.
	Lo-bandStart	Identifies the duplexer’s start low-frequency range. Valid start low-band
		pass is 0 to 65535 MHz. When setting the start low-frequency range for the
		duplexer, this range of values must be lower than the range specified for the
		Hi-bandStart parameter.
	Lo-bandEnd	Identifies the duplexer’s end low-frequency range. Valid end low-band pass
		is 0 to 65535 MHz. When setting the end low-frequency range for the
		duplexer, this range of values must be lower than the range specified for the
		Hi-bandEnd parameter.
	Hi-bandStart	Identifies the duplexer’s start high-frequency range. Valid start high-band
		pass is 0 to 65535 MHz. When setting start high-frequency range for the
		duplexer, this range of values must be higher than the range specified in the
		Lo-bandStart parameter.
	Hi-bandEnd	Identifies the duplexer’s end hi-frequency range. Valid end high-band pass
		is 0 to 65535 MHz. When setting end hi-frequency range for the duplexer,
		this range of values must be higher than the range specified in the
		Lo-bandEnd parameter.
	Tx-insertion-loss	Specifies the transmit insertion loss for the duplexer, in dB. The insertion
		loss of the duplexer is the degree to which it attenuates the signal passing
		through its pass-bands. Valid range is 0 255 dB.
	Tx-lo	Indicates that the low-frequency range is used for transmission, which
		implies that the high-band frequency range is used for reception. Valid
		frequency range is 0 to 65535 MHz.
	Tx-hi	Indicates that the high-frequency range is used for transmission, which
		implies that the low-band frequency range is used for reception. Valid
		frequency range is 0 to 65535 MHz.
Defaults	No default behaviors and values.
Command Modes	Privileged EXEC

Cisco IOS Release 12.1(5)XM

62