Pengo Computer Accessories UBR7200 manual Loopback, Syntax Description

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

loopback

loopback

To place the specified module in loopback mode, use the loopback interface configuration command. To remove the loopback specification use the no form of this command.

loopback local [module] [main diversity] subchannel

no loopback [local module]

Syntax Description	local	(Optional) Specifies that the module is local.
	module	Specifies the type of module:
		{fir if rf}
	main diversity	Specifies the main or the diversity (backup) antenna.
	subchannel	[2 3] Specifies the subchannel numbers.

Defaults

Command Modes

Command History

no loopback

Interface configuration

ReleaseModification

12.1(3)XQ1 This command was introduced.

Usage Guidelines	If you perform a loopback of the RF module while the transverter is attached to an antenna, some
	transmit power is radiated. Therefore, it is extremely important that you set the transmit frequency to
	your assigned and licensed band frequency. If the transverter is not attached to an antenna, attach an RF
	termination device to the duplexer port.
Examples	The following example shows how to initiate a local RF loopback on the main antenna with the lower
	half of the subchannel:
	Router(config-if)#loopback local rf main 2
Related Commands	Command	Description
	show	Displays loopback configuration settings.
	running-configuration

Cisco IOS Release 12.1(5)XM

25