Pengo Computer Accessories UBR7200 manual Pppoe forwarding group, Interface

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

pppoe forwarding group

pppoe forwarding group

To set a PPP over Ethernet forwarding group number on the radio interface, use the forwarding group interface configuration command. To disable forwarding group assignment, use the no form of this command.

forwarding group group-num

no forwarding group group-num

Syntax Description	group-num	Specifies PPPoE forwarding group number. Valid range is 1 to 10.
Defaults	No default behaviors or values.

Command Modes

Command History

Interface configuration

ReleaseModification

12.1(3)XQ1 This command was introduced.

Usage Guidelines	The forwarding group command needs to be set on both the radio interface and the ATM or permanent
	virtual circuit (PVC) interface. The forwarding engine maintains an internal table of the forwarding
	group. The forwarding group information from the internal table is used for forwarding packets between
	the radio interfaces and the ATM or PVC interfaces. The group-numvalue needs to be the same on both
	the radio and the ATM or PVC interfaces. For more information about configuring PPPoE on an ATM
	or PVC interface refer to the PPP over Ethernet document.
Examples	The following example shows how to set the PPPoE forwarding group number to 1 for the radio
	interface:
	Router(config-if)# forwarding group 1
	The following example shows how to configure the forwarding group on the ATM or PVC interface:
	router(config)# int atm2/0.1 p
	router(config-subif)# pvc 0/60
	router(config-if-atm-)# forwarding group 1

Cisco IOS Release 12.1(5)XM

31