Pengo Computer Accessories UBR7200 Radio cable-loss, No radio cable-loss, Release Modification

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

radio cable-loss

radio cable-loss

To specify the effective cable loss (measured in dB) of the cable between the wireless card and the specified wireless transverter, including the power feed panel, connectors, and lightning protection, use the radio cable-lossinterface configuration command. To remove the setting, use the no form of this command.

radio cable-loss{auto antenna_num tx_loss rx_loss}

	no radio cable-loss
Syntax Description	auto	The radio modem automatically determines the cable loss compensation for
		the specified antenna.
	antenna_num	Enter 1 for the main antenna or 2 for the diversity antenna.
	tx_loss	Positive number (less than or equal to 15 dB) that reflects the effective
		transmit cable loss at 330 MHz.
	rx_loss	Positive number (less than or equal to 13 dB) that reflects the effective
		receive cable loss at 426 MHz.

Note The cable loss parameter cannot be set to a value greater than 13 dB for rx-lossand 15 dB for tx_loss. The exact cable-loss value is determined by the transverter. The system compares this value to the value when a no shut command is entered. To display the current cable loss setting, use the show running-configuration interface radio command.

Defaults	No default behaviors or values.
Command Modes	Interface configuration
Command History	Release	Modification
	12.0(1)XR	This command was introduced.
	12.1(3)XQ1	Support for multipoint was added.

Cisco IOS Release 12.1(5)XM

37