Pengo Computer Accessories UBR7200 manual Radio upstream frequency, 105

Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router

radio upstream frequency

radio upstream frequency

To specify the upstream radio frequency, use the radio upstream frequency command. To disable this function, use the no form of this command.

radio upstream frequency [freq] width [width]

no radio upstream frequency

Syntax Description	freq	The frequency in kHz (dBs are allowed). Valid range is 0 to 50000000 kHz.
	width	The keyword used for specifying the bandwidth.
	width	The bandwidth in MHz. The width must be supported by the RF/IF
		modules.
Defaults	The default bandwidth will depend on the band that your multipoint system uses.

Command Modes

Command History

Interface configuration

ReleaseModification

12.1(3)XQ1 This command was introduced.

Usage Guidelines The radio interface cannot be enabled unless a center frequency is specified. Specify the center frequency and the badwidth for the whole upstream channel group. The following is a pictorial representation of the center frequency:

freq

1

23

4 5 6 7

width

35542

Examples	The following example shows how to set the upstream center frequency for the radio mode in slot 6,
	port 0:
	UBR(config-if)#interface radio 6/0 radio upstream 0 frequency 5700000

Cisco IOS Release 12.1(5)XM

105